Leather and Footwear Journal

Volume 2, no 1

Identification Methods of Surface Faults, Typical for Rubber Goods. Part II
- Laurenţia ALEXANDRESCU, Zenovia MOLDOVAN
  
  ABSTRACT. Simultaneous with the development of production of rubber goods have appeared also problems regarding defect son the surface of certain products. To avoid these qualitatively undesirable phenomena, as well as for products partial recovering, there were elaborated identification methods of the substances which can exudates on the rubber goods that are chromatographic methods, gas or liquid chromatography tandem techniques, coupled with mass spectrometry, spectrometric and microscopic methods.
  
  KEY WORDS: rubber goods, defects on the surfaces, identification method, chromatographic methods, mass spectrometry
New Materials for Rubber Industry
- Florica IONESCU
  
  ABSTRACT. The dynamic elastic-plastic composition is a new thermo plastic elastomer class obtained by interactive mixing of elastomer with plastomers, in the presence of curing agents. Using the dynamical curing proceeding of elastomers and polyolefin’s in presence of curing agents it results thermoplastic cured products with higher properties due to the resulted material structure: micronical particles of cross linked rubber dispersed in the polymer mass.
  
  KEY WORDS: elastomer, plastomers polyolefin, thermoplastic cured products
„Total Design” Stylistic and System’s Research about Footwear
- Marlen POP
  
  ABSTRACT. The paper intends to define and explain the „Total Design” concept, which means the organization of entire creation process of clothes. The “Total Design” with its two components” stylistic research and the performing design basics-have a special significance in clothing creation, being applied from the incipient creating phase of the new models.
  
  KEY WORDS: “Total Design”, organization, entire creation process, clothe, stylistic research
Non conventional assembling technologies – a solution for Manufacturing of water proof and protective clothiers, even in Nuclear field
- Carmen LOGHIN, Ecaterina PINTILIE
  
  ABSTRACT. The new requirements that govern the garment functional design have a great influence on the adequate technological assembly selection. Though the welding technology is a very old one, today is actualize and perfected because the technological effects is correlate with the needs of the customer, respectively the total waterproofing of the garment, even in the sewing zones. The paper proposes some criteria to select the right proceed according to the fabrics characteristics and technological scope.
  
  KEY WORDS: protective clothiers, non conventional assembling technologies criteria
Possibilities for Perfection of Organizing Work Time to “Artima” SA Chişinău Moldova
- Marina MALCOCI, Voinea COCIU
  
  ABSTRACT. This paper exhibits the achieved study on the structure of the performer work time, in evolving productive time and un productive time, which contain, each of them, some other components. The quality of operation, work productivity, using degree of equipments depends of using efficiency work time. The researches took place at ARTIMA SA Chisinau. A questionnaire was made, to which answered 100 workers and depending on the resulting data, there were drawled the circular diagrams.
  
  KEY WORDS: study, productive time, quality of operation Using efficiency work time